Impala Forums banner

1 - 6 of 6 Posts
I

·
Guest
Joined
·
0 Posts
Discussion Starter #1
I have a 2001 3.4L chevy impala and I want to get a K&N cold air intake for it. And they only sell it for 3.8L. I was wondering if the 3.8L has the same intake set up as a 3.4L?
 
D

·
Guest
Joined
·
0 Posts
Discussion Starter #2
no. they won't work the 3.4 is a spin off of the 3.1. you should be able to track down a good used 3.4 manifold through a salvage yard. good luck
 
B

·
Guest
Joined
·
0 Posts
Discussion Starter #3
same engine setup just bigger displacement. buy it , try it ,and if it dont work take it back
 
M

·
Guest
Joined
·
0 Posts
Discussion Starter #4
I really doubt it the engine block is different the 3/4 is a 60 degree V6 the 3.8 is a V8 with 2 cylinders removed and is a 90 degree V6 . If K&N says it dosen't fit I would beleve them.
 
G

·
Guest
Joined
·
0 Posts
Discussion Starter #5
Will not work. The engines have a slightly different air intake setup. I have heard that the kit from SLP will work, just keep the stock air hose. (see link below) There are other DIY options, check out the ideas that are linked below. This should give you plenty of idea on what you can do with your car. FWIW, you can build your own intake from ABS and a K&N filter for uner $100.
 
H

·
Guest
Joined
·
0 Posts
Discussion Starter #6
Definitely not, the motors are not even close in design measurements.
 
1 - 6 of 6 Posts
Top