Impala Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
94 Posts
Trans

TH400 should fit. So will a lot of buick/pontiac transes. The locating pins and center upper bolt hole and lower holes are in the same places. Just make a couple of half moon shaped metal brackets to bolt the remaining block holes to the upper ears on the bellhousing. Done that a few times on daily drivers just fine.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top