Impala Forums banner

1 - 1 of 1 Posts

·
Registered
Joined
·
14 Posts
Discussion Starter #1
First things first, this is for a 2013 Impala 3.6. I’ve done quite a bit of searching here and elsewhere and can’t find much about removing the intake manifold. I typically do this with most of my cars to give them a nice cleaning, and my car is pushing 145k so I figure it could use a cleaning. I know about seafoam, but I prefer cleaning more thoroughly. I’m good at figuring things out, but have never worked with these motors, and it would make it a lot easier if anyone has a write up, or any advice/tips when it comes to removing the manifold. Thanks
 
1 - 1 of 1 Posts
Top