Impala Forums banner

1 - 7 of 7 Posts

·
Registered
Joined
·
121 Posts
Discussion Starter #1
I have a kicker ZX750.1 and 2 brand new CVR 12s, this is my first experience with DVC subs and having a little trouble with wiring believe. I have them wired according to a cructhfield diagram for 2 ohms.

Now the problem is when every I attempt to tune my amp once it gets passed a certain level it goes into power protection mode for 10 seconds, starts playing for about 5 then back in to power protection again. I dunno if its something I did wiring the subs or what but I heard that that amp is 1 ohm stable so I cant really figure out why it would be shutting off like that while Im attempting to tune it.

once it stops raining here I was gonna pull it apart to check the wiring again and make sure nothings hanging but from my end it all looks good.]=
 

·
Registered
Joined
·
913 Posts
What ohm are your subs?
How do YOU have them wired?

Sounds like a clipping problem. Meaning you're not suppling enough power to the amp. Ever notice your battery gauge taking a nose dive when you bump it?
 

·
Registered
Joined
·
121 Posts
Discussion Starter #4
The subs are 2 ohms, I have the wiried according to crutchfields 2 ohm diagram.
i think my power wire is either 4 or 8 gauge.
And Ill check the ground Im not sure where else to put it.
 
1 - 7 of 7 Posts
Top