Impala Forums banner

1 - 3 of 3 Posts

·
Registered
Joined
·
4 Posts
Discussion Starter #1
I have been looking through quit a few posts about the "no heating at idling" issue. The general answer is to bleed the cooling system. I have read quit a few different ways to do this,which way is the most efficient/easiest on a 2010 Impala LT? thanks guys!
 

·
8th Gen Antagonist
Joined
·
13,660 Posts
Open the cap, fill, squeeze the upper hose to release the bubbles, fill again, repeat until no more bubbles. Top off reservoir, and the rest should bleed out driving with the heater on.
 
1 - 3 of 3 Posts
Top