Impala Forums banner
1 - 7 of 7 Posts

·
Registered
Joined
·
1,556 Posts
Discussion Starter · #1 · (Edited)
i just replaced my front sway bar end links do to rot and 200000 plus miles my quesion is how tight should i tighten them should it be rubber to rubber tight or a little looser than that any help is appreciated
 

·
Registered
Joined
·
1,556 Posts
Discussion Starter · #3 ·
thANX BUDDY:biggrin:
 

·
Registered
Joined
·
1,556 Posts
Discussion Starter · #5 ·
thank you also buffman the answer i was looking for so in other words pretty close to as tight as it will go right:confused:
 

·
Registered
Joined
·
184 Posts
No. You can get it much tighter than 13ft-lbs if you aren't carefull. I broke 3 sets of end-links this way.

Be careful not to over tighten. Go just until the bushings squish.
 

·
Registered
Joined
·
1,556 Posts
Discussion Starter · #7 ·
thanx again ltz:biggrin:
 
1 - 7 of 7 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top