T
The Chimp
·Guest
Joined
·
0 Posts
lower bolt on housing, no room.. I removed the airbox, but theres no way I can get the lower bolt out of the thermostat housing. Anyone have a step by step instruction on how they did this?
How do I change the thermostat on a 2003 chevy impala 3.4 v6? Cant remove the
Join the discussion
Recommended Reading
-
P0449 2016 Impala (New Body Style)
Mechanical and Electrical ProblemsJust recently had my check engine light come on for P0449. At the time the CEL came on, my EVAP Purge Valve was constantly actuating at idle, so I replaced that first. (See picture) I cleared the CEL and reset the computer by disconnecting the negative battery cable for several minutes and...- 15
- 1K
-
kylelally77 · updated
-
2005 impala v6 3.4l, front end shakes under acceleration
Mechanical and Electrical ProblemsI've put brand new tires, struts and left side cv axle on and the shake is still there. I'm replacing the right side cv axle today. Is there anything else that will cause the front end to shake when you accelerate?- 4
- 262
-
Brianfox37 · updated
-
I have a 2005 chevy impala,the speedometer quit working and the temp gauge?
Mechanical and Electrical Problemsplease help I cant afford a machanic- 14
- 55K
-
2005 - No low beams, Hi beams OK
Mechanical and Electrical ProblemsI have a 2005 Impala. The signal/wiper column lever would suddenly not allow me to change between hi and lo beams; only allowing to stay on hi beam. The next day, the switch began working again, although the clicking sound was gone (when switching the beams). I noticed lo beams not working at...- 10
- 7K
-
2008 Chevrolet Impala LT 3.9L stalled with DTC P0016
Mechanical and Electrical Problems2008 Chevrolet Impala LT 3.9L stalled with DTC P0016. Towed home and replaced camshaft position sensor and crankshaft position sensor and inspected connecting wires. Also checked that camshaft actuator solenoid operation by pulling and applying power and checked that the actuator on the camshaft...- 3
- 5K
Join now to ask and comment!