Impala Forums banner
1 - 3 of 3 Posts

·
Registered
2014 Chevy Impala LT 4-Cyl 2.5
Joined
·
3 Posts
Discussion Starter · #1 ·
Hi! Let me start by saying I’m a 25y/o female with very little experience with vehicles. I have lurked around on this forum for a while and finally decided to to make an account and post my issue in hopes someone can help.
I own a 2014 Impala LT 2.5 4cyl 119,000mi This car is beautiful.
Recently having issues that the car wants to die at stop lights. Never while driving down the road, only at stop lights while idling the car will get shaky and sputtery and either act like it’s going to die or does die. Hit the gas, car doesn’t die. Long story short, one day idling in my drive, stabilitrak pops on, reduced engine power and car dies. Code for fuel pressure regulator pops up. Autozone says regulator is in the fuel pump so I’m going to buy the parts to replace the pump.
NOW I’m dealing with a P0016 AND P0017 and a high pitched squeal on start up and the internet basically says you’re out of time. Codes read camshaft/crankshaft position sensors. My dad has done all the mechanical work on my car. This is my third Impala (‘13 totaled in accident, ‘08 traded for ‘14) but 119,000mi seems a little early for timing problems based off everything I’ve read? I’ve read car has a timing BELT not a chain, is that right? Because I can’t seem to find a belt for my vehicle. Would changing the sensors help or am I basically SOL and need a whole timing kit?
I have little experience with vehicles let alone tearing apart a whole engine but I would rather gain the experience working on it myself with my own research(YouTube lol) and a couple hundred dollar parts instead of throwing down thousands and not gaining any knowledge about my vehicle in the process.
Anyway, I’m sorry this is so long to read. Does this vehicle have a belt or a chain? Where is the best place to purchase parts from? I am looking at RockAuto.
 

·
Registered
2014 Chevy Impala LT 4-Cyl 2.5
Joined
·
3 Posts
Discussion Starter · #8 ·
The quick test for this issue is when the engine is running and will not idle (stalls) if you remove the oil fill cap on the engine the car will now idle. Now add the codes you have and you can look at the high pressure fuel pump for replacement.
Do not forget to change engine oil and filter (it has been contaminated with gas).HTH
John
The actual code reads “Crankshaft position, Camshaft position correlation Bank 1 sensor A” and I also have this same code for sensor B. I read your previous reply about running too rich and before my problems persisted I had a code for system too lean, not rich. That code went away after bit. Now the only codes I have are the p0016&17 and the code for fuel pressure regulator. Fuel pressure regulator only popped up when stabilitrak (reduced engine power) came on and my car died. Been letting her sit ever since until I get it figured out lol.
 

·
Registered
2014 Chevy Impala LT 4-Cyl 2.5
Joined
·
3 Posts
Discussion Starter · #10 ·
OK the lean code is from the O2 sensor trying to change the fuel to a lean condition because of the extra fuel in the engine oil. The high pressure fuel pump is mounted on the top area of the engine (this unit leaks fuel into the engine) not hard to replace, but look at some of the You-Tube videos on replacement they can be helpful.
Thank you for all of your help. I am gunna get that changed asap! I have no problems changing the fuel pump but I really really didn’t want to have to change the timing chain. Everything I’ve read on that P0016&17 code is timing chain related from what I can tell. Whew.
 
1 - 3 of 3 Posts
Top