[Mkinn]

I know a lot of people use hot air guns to heat up the glue behind the badge and then use fishing string to remove the badge. What do you guys think about using a HOT Pressure washer unit. Low pressure and high heat. I have access to one and i'm not to comfortable with using a heat gun. I was thinking steam would be a better/safer way to remove the badges. Any suggestions/comments/concerns would be greatly appreciated it. Thanks Guys!

 

[Mkinn]

so i don't even need heat?

 

[Mkinn]

so i just went outside and used sewing thread and took off the two GM badges off the front and it looks great. next is the IMPALA on the trunk and the bowtie, the bowtie is held on just by glue right? i'm not going to uncover a hole am i?

 

[Mkinn]

yeah i did the trinkits last night and went out this morning to take off the bow tie but i believe its just to cold out, i'm going to wait till we have a day thats above freezing before i do the trunk....does dental floss not break as easy as sewing thread and fishing line? i would think it would break easier..