Impala Forums banner
1 - 2 of 2 Posts

·
Registered
Joined
·
42 Posts
Discussion Starter · #1 · (Edited)
So i had to replace the rear head on my car due to a previously repaired rocker arm stud backing out again. During the process, I decided to replace my timing set even though it's at 189,000 miles with no timing issues. After I pulled the intake manifold, I went to pull the connector off of the sensor and all 3 wires came out ofit. Does anyone know which wire goes where in this thing? I ordered a new one, just can't seem to find this layout anywhere.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top