Impala Forums banner

BCM Blowing Fuses

1K views 10 replies 4 participants last post by  Impoor  
Yes, it's possible. The BCM has a few different connections to the ABS and EBCM (electronic brake control module). iirc, the fuse for the wheel sensors is 60A but the fuse for the BCM is only 10A. The water might have caused enough resistance across the data line to blow the BCM fuse but not the sensors' fuse.

No way to say for sure if this is the culprit though without spending some time testing the wiring with a multimeter. That service bulletin may be a factor, or the wiring harness may be damaged somewhere or you may have a bad ground.

I would stash a few extra fuses in the glove box and keep an eye on it for a while to see how it goes.