Impala Forums banner

96 9c1 front brake caliper question

2018 Views 2 Replies 2 Participants Last post by  55lasombra
Hi everyone....Just replaced my front spindles on my 1996 9c1.When installing the brake calipers the passenger side went in fine.The drivers side was to tight to be installed without grinding some material of the caliper contact area.:cool:
Does anyone know how much space there should be between the caliper and spindle/knuckle contact pad area?:dunno::
How freely should the caliper slide?
I dont want the caliper to hang up when it heats up,however if it is to loose it might be noisy..
Should the contact pad area be greased?
Thank You...:yikes:
1 - 1 of 3 Posts
You sure the bolt guides arent pushed in? Not sure if I got the right name, but the little steel tubes the bolts slide through.
1 - 1 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.