Impala Forums banner

1 - 1 of 1 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter #1
Hi, I am knew to the forum.Please inform me if I do not follow procedures correctly.I have recently taken my 3.4 apart and had parts machined.
I had the cylinders bored over and got new rebuild kit for engine.I have torqued my mains and oil pump down.
But now I cannot figure out which way rods go back in there are markings on them but i cannot figure out there meanings.so how do you tell which way they go? they say 2 574 on 4 rods on one side.On one it has 1 574 and on the last one its B574 any help would be much appreciated.I did have them in order until the machine shop got them mixed up.Any help would be much appreciated
 
1 - 1 of 1 Posts
Top