Impala Forums banner
2012
1-3 of 3 Results
  1. Chevy Impala 9th Gen Discussion
    I could really use some advice here please. So I have a 2012 Chevy Impala LT FE2 suspension. I have replaced the following on both front axels: steering knuckles, lower ball joints, wheel hub assembly, wire harness from speed sensor to main loom, sway bar link bushings, inner & outer tie rods...
  2. Chevy Impala 8th Gen Discussion
    I have a 2012 chevy impala with 88000 miles. The air conditioner stopped working for about a week. I was gonna replace the blower motor but before I got to it after a short couple hour trip I got a message saying that the engine power is reduced, stabilitrak needs serviced and traction control...
  3. Chevy Impala 8th Gen Discussion
    Hello All, I found in the 2012 Chevrolet Municipal Vehicles Technical Manual on page 72 it mentions a "Trunk Auxiliary Battery Power Junction Block" and a "Trunk Ground Stud" that are located "on the passenger side support strut behind the rear wheel housing" of the Impala 9C1 and 9C3. Would...
1-3 of 3 Results
Top