Chevy Impala Forums - Reply to Topic
Buick Roadmaster General and Technical discussion for the B-Body Buick Roadmaster (1991-1996) and Oldsmobile Custom Cruiser (1991-1992).

Thread: Lean running Roadmaster Reply to Thread
Title:
Message:
Trackback:
Send Trackbacks to (Separate multiple URLs with spaces) :
Post Icons
You may choose an icon for your message from the following list:
 

Register Now



In order to be able to post messages on the Chevy Impala Forums forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.

User Name:
Password
Please enter a password for your user account. Note that passwords are case-sensitive.

Password:


Confirm Password:
Email Address
Please enter a valid email address for yourself.

Email Address:
OR

Log-in










  Additional Options
Miscellaneous Options

  Topic Review (Newest First)
11-07-2012 11:10 PM
jeffs409
Lean

Duke may have the answer, and that would be great, however if it is not, Mr Buick's suggestion is one I always tell people. On fuel injected vehicles or Harleys ( ex master tech ) low pressure can act like so many things. Low power, stumbling, act like you have an ignition problem etc. Your car should run a little rich when first starting up and then as it warms to temp it will reduce the AF ratio accordingly.

Jeff
11-07-2012 09:09 AM
DukeOfEarl
Lean on both banks

My '96 Roadmaster had the check engine light on for a couple of years with a code that indicated lean on both banks. Seemed to run OK, although the gas mileage was down a bit. I recently discovered the problem when I heard a very slight hissing noise near the engine cover: The short rubber elbow right at the PCV valve (left side of the engine) was clogged up AND had a hole in it. Problem solved!!
05-20-2011 12:42 AM
MrBuick (Magnum) Any time there is an issue like this, check the fuel pressure. It would have saved me a tone of work when I had an issue like this. I normally change the fuel filter for the hell of it, when an issue like this happens. It's only a good thing to change that filter, as it is often forgotten.

My first RMS was goofy. Some days it seemed fine, other days is ran like crap. Sometimes in the same few minutes it would change from fine, to running like crap.

Adjustable fuel pressure regulators only true place is on a forced induction car. Or a car using injectors that are maxed out, and you need more out of them. Either way, using one requires a custom tune. The LT1 PCM is very smart. Try to trick it by adjusting the fuel pressure, and it will figure it out. It will figure it out, and make an adjustment. Like guys who were pulling the fuel PSI on stock tunes, to have it run leaner, and make more power. Within a week or so, the PCM figured it out, and was back where it had been before the change.

You want to use one as a bandaid, because you are too lazy to look for the real issue. Really?? Find the sensor, or wire, or item that was causing it, and you won't need any special parts. Might take some time to trouble shoot, but there are not many sensors, and they are all easy to check. Most can be done with a volt meter, and a pair of safety pins.
05-11-2011 11:24 AM
houimpala96 Naw. An ajustable fuel regulator could do it, but you dont need it. Maybe one of your O2 sensor are out and sending wrong messege to pcm. That can make the car run lean or rich.
05-11-2011 09:31 AM
jtg
Lean running Roadmaster

It seems to run OK after a few minutes, even when I floor the throttle and it downshifts. Before it warms up a little, it will pop, since it is lean. Is there any kind of device on it that increases fuel flow when cold? I have not checked fuel pressure yet.

Thanks, jtg
05-11-2011 05:33 AM
houimpala96 Check your fuel pressure and see where its at. If its under 40psi then you may have a slight problem.
05-11-2011 05:32 AM
houimpala96 How does it run when you are driving it?
05-10-2011 03:22 PM
jtg
Lean running Roadmaster

I am a new member, hope I can get some help. I have a 1996 Roadmaster sedan with the 5.7 LT1 motor. The computer code shows lean in left and right bank. This problem showed up rather suddenly. It ran fine, then I had difficulty starting it after it was not run for several days.

Once I get it running, it is obviously lean if I try to accelerate for a few minutes, then it seems to run OK.

If it were the fuel filter or fuel pump, it seems it would not get better after a few minutes of running.

I would appreciate any ideas. Thanks, jtg

Posting Rules  
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

 
For the best viewing experience please update your browser to Google Chrome